Explanation of pad control functions in a Freescale processor?

Question

Reading the MCIMX50 Application Processor Reference Manuals on page 1368 (Section 33.3) there is a list of the different possible control functions of the processors pads.

The list is:

SRE (1 bit slew rate control).
DSE (2 bits drive strength control).
ODE (1 bit open drain control).
HYS (1 bit hysteresis control).
PULL_KEEP_CTL (4 bits pull up/down and keeper controls)
PUS (2 bits pull up/down configuration value)
PUE (1 bit pull/keep select)
PKE (1 bit enable/disable pull up, pull down or keeper capability)
DDR_MODE_SEL (1 bit ddr_mode control)
DDR_INPUT (1 bit ddr_input control)

Can someone explain what each one of these are, preferably in an educative manner with links to additional information?

Thanks in advance.

score 10 · Answer 1 · edited Sep 22 '22 at 02:10

10

There is more detail on this in app note AN5078 on the Freescale site.

Link: https://www.nxp.com/docs/en/application-note/AN5078.pdf

Summarized: The keeper keeps the output level the same even if you turn the driver off. There's an associated internal resistance of ~130kohms, so it won't drive much but it'll keep the pin from floating.

edited Sep 22 '22 at 02:10

youfu

1,547
3
15
21

answered May 27 '15 at 16:37

David Fenger

101
1
2

1

Official documentation! Fantastic! Thank you. :) – Bjarke Freund-Hansen May 29 '15 at 08:45

score 9 · Accepted Answer · answered Jun 27 '12 at 16:00

SRE (1 bit slew rate control) - How fast the pin state changes from 0 to 1, since rapidly changing states takes more power & emits RF spikes, slowing it down if you can helps EMC. We run most of our GPIO pins at low slew rate apart from SPI & I2C which need to be fast.

DSE (2 bits drive strength control). - How much current the IO pin will source/sink, again a power-saving / EMC thing as it's generally bad practice to hang loads directly from micro pins.

ODE (1 bit open drain control). - Whether the pin pulls down to 0V for a low output or goes "open drain" (disconnected/floating), this is useful for some things like I2C where parts take it in turns to hold lines low or high.

HYS (1 bit hysteresis control). - Look up Hysteresis on wikipedia, should tell you all you need to know.

Pullups/downs etc. - basically whether the pin has an internal resistor connected to +v or 0v to stop things floating to some random/undesired value, usually used when the pin is an input.

DDR_MODE_SEL (1 bit ddr_mode control) - Probably Data Direction Register, in other words is the pin an input or output

DDR_INPUT (1 bit ddr_input control) - Not sure, the micro reference manual should give you some clue to this and all the others.

Hope this helps!

You missed explaining what a Keeper is. Pull ups and downs are self explanatory... keeper is not. — AllenKll, Jun 18 '14 at 13:59

Explanation of pad control functions in a Freescale processor?

2 Answers2