1

I am trying to jump into OPC UA. I have a test KepServerEX OPC server set up with UA enabled. Have the two default endpoints setup and enabled. I am using UAExpert to connect to the OPC server so I can browse tags. I connect just fine, but the only node showing up is the server node. There should be at least 3 other nodes showing because there are 3 channels set up with a device in each. Two of these are simulation devices that have tags defined, the other is a connection to a PLC. I cannot seem to get those other nodes to show up. I looked everywhere for any kind of settings that might prevent browsing of these nodes. I cannot find anything. Both client and server are running on the same computer. Any ideas?

Tried searching the internet and the Kepware documentation.

eglease
  • 2,445
  • 11
  • 18
  • 28
DVanKeuren
  • 11
  • 1
  • Please clarify your specific problem or provide additional details to highlight exactly what you need. As it's currently written, it's hard to tell exactly what you're asking. – Community May 25 '23 at 05:39

0 Answers0