ST Link V2 "No STLink detected" in STM32CubeIDE and ST Link Utility

Asked Feb 27 '23 at 12:31

Active Feb 27 '23 at 12:31

Viewed 438 times

The device was working fine till last week, now when I try to debug the STM32cubeIDE indicates "No ST Link found". On hardware side, there are no LED glowing on the STLink board.

Before concluding that the STLink V2 is dead, I would like to check if there are any workaround to try to revive the device, if I try to upgrade the firmware, then the STlink V2 is not detected as expected. The same observation is in the ST Link Utility tool. Is there any other way that I can try, request for suggestions and help.

I am using windows10 PC.

Thank you.

asked Feb 27 '23 at 12:31

babyCoder

Is it an original or pirat Chinese copy of st-link board? – 0___________ Feb 27 '23 at 12:42
Its original stlink V2 board – babyCoder Feb 27 '23 at 12:51
Did you install the drivers? – 0___________ Feb 27 '23 at 12:52
Yes I had installed all necessary drivers, as said it was totally working fine till last week. And I had been using this board from a long time. – babyCoder Feb 27 '23 at 13:12
Then it is dead ⛼ – 0___________ Feb 27 '23 at 13:19

ST Link V2 "No STLink detected" in STM32CubeIDE and ST Link Utility

0 Answers0