Trying to change IP config on Zebra printer with SGD code

Asked Mar 19 '20 at 20:52

Active Mar 20 '20 at 03:07

Viewed 297 times

I am trying to configure the IP, subnet, and gateway addresses on a zebra ZT410 printer with SGD commands.
I am using the "Zebra setup utility", my getvar commands work, but setvar commands do not work. What Am I doing wrong ? My code is below...

! U setvar "internal_wired.ip.addr" "100.100.100.101" 
setvar "internal_wired.ip.netmask" "255.255.255.0" 
setvar "internal_wired.ip.gateway" "100.100.100.254" 
END

edited Mar 20 '20 at 03:07

Delphi Coder

1,723
1
14
25

asked Mar 19 '20 at 20:52

Komakino_1251

add a 1 after the U so "! U1 setvar... – banno Mar 19 '20 at 21:07
Tried it, still did not change the values . – Komakino_1251 Mar 19 '20 at 21:09

Trying to change IP config on Zebra printer with SGD code

0 Answers0