This is part comment, part answer.
In engineering terms, the original function posted is using "brute force" to solve the problem, iterating every (or more than needed) possible combinations. The number of iterations is n is large - if you did all possible it would be
n * (n-1) = bazillio n
Less is More
So lets look at things that can be optimized, first some minor things, I'm a little confused about the first for loop and nArray:
// OP's code
for(let i = 1; i <= n; i++) {
nArray.push(n - (n - i));
sum += i;
}
??? You don't really use nArray for anything? Length is just n .. am I so sleep deprived I'm missing something? And while you can sum a consecutive sequence of integers 1-n by using a for loop, there is a direct and easy way that avoids a loop:
sum = ( n + 1 ) * n * 0.5 ;
THE LOOPS
// OP's loops, not optimized
for(let i = Math.round(n/2); i < length; i++) {
for(let y = Math.round(n/2); y < length; y++) {
if(i != y) {
if(i*y === sum - i - y) {
Optimization Considerations:
I see you're on the right track in a way, cutting the starting i, y values in half since the factors . But you're iterating both of them in the same direction : UP. And also, the lower numbers look like they can go a little below half of n (perhaps not because the sequence start at 1, I haven't confirmed that, but it seems the case).
Plus we want to avoid division every time we start an instantiation of the loop (i.e set the variable once, and also we're going to change it). And finally, with the IF statements, i and y will never be equal to each other the way we're going to create the loops, so that's a conditional that can vanish.
But the more important thing is the direction of transversing the loops. The smaller factor low is probably going to be close to the lowest loop value (about half of n) and the larger factor hi is probably going to be near the value of n. If we has some solid math theory that said something like "hi will never be less than 0.75n" then we could make a couple mods to take advantage of that knowledge.
The way the loops are show below, they break and iterate before the hi and low loops meet.
Moreover, it doesn't matter which loop picks the lower or higher number, so we can use this to shorten the inner loop as number pairs are tested, making the loop smaller each time. We don't want to waste time checking the same pair of numbers more than once! The lower factor's loop will start a little below half of n and go up, and the higher factor's loop will start at n and go down.
// Code Fragment, more optimized:
let nHi = n;
let low = Math.trunc( n * 0.49 );
let sum = ( n + 1 ) * n * 0.5 ;
// While Loop for the outside (incrementing) loop
while( low < nHi ) {
// FOR loop for the inside decrementing loop
for(let hi = nHi; hi > low; hi--) {
// If we're higher than the sum, we exit, decrement.
if( hi * low + hi + low > sum ) {
continue;
}
// If we're equal, then we're DONE and we write to array.
else if( hi * low + hi + low === sum) {
answersArray.push([hi, low]);
low = nHi; // Note this is if we want to end once finding one pair
break; // If you want to find ALL pairs for large numbers then replace these low = nHi; with low++;
}
// And if not, we increment the low counter and restart the hi loop from the top.
else {
low++;
break;
}
} // close for
} // close while
Tutorial:
So we set the few variables. Note that low is set slightly less than half of n, as larger numbers look like they could be a few points less. Also, we don't round, we truncate, which is essentially "always rounding down", and is slightly better for performance, (though it dosenit matter in this instance with just the single assignment).
The while loop starts at the lowest value and increments, potentially all the way up to n-1. The hi FOR loop starts at n (copied to nHi), and then decrements until the factor are found OR it intercepts at low + 1.
The conditionals:
First IF: If we're higher than the sum, we exit, decrement, and continue at a lower value for the hi factor.
ELSE IF: If we are EQUAL, then we're done, and break for lunch. We set low = nHi so that when we break out of the FOR loop, we will also exit the WHILE loop.
ELSE: If we get here it's because we're less than the sum, so we need to increment the while loop and reset the hi FOR loop to start again from n (nHi).
