I am using Debian on Raspberry Pi 3. I am trying to create IR remote. I am following online tutorials. I could record my remote using IR receiver but while emitting IR, I am getting following error:
irsend: command failed: SEND_ONCE Samsung KEY_POWER
irsend: transmission failed
I tried everything I could using google, but no progress.
After searching and trying do many different things, finally i found the solution. There were several problems in my configuration. The two steps below fixed my problem:
1) Raspberry pi default gpio control was overriding lirc configuration. To solve this i restarted lirc using below command
sudo /etc/init.d/lirc restart
2) Set lirc device manually
sudo lircd --device /dev/lirc0
Also i used 1k resister instead of 10 k in setup.
Thanks anyway!
set my lirc device mannualy
