How to flash STM32 via Serial Port

Question

I have an STM32F102 microcontroller and I want to program it via the Serial Port.

While there is a flasher available for windows, I want to do it on a Linux Machine. I tried doing it with this script

I have set BOOT0 = 1 and BOOT1 = 0, restarted the microcontroller. But it does not work. I get the following output

Can't init. Ensure BOOT0=1, BOOT1=0, and reset device
Traceback (most recent call last):
  File "stm32loader.py", line 552, in <module>
    bootversion = cmd.cmdGet()
  File "stm32loader.py", line 140, in cmdGet
    if self.cmdGeneric(0x00):
  File "stm32loader.py", line 137, in cmdGeneric
    return self._wait_for_ack(hex(cmd))
  File "stm32loader.py", line 88, in _wait_for_ack
    raise CmdException("No response to %s" % info)
__main__.CmdException: No response to 0x0

I think this will be impossible to reproduce without having access to your specific system. There could be numerous causes for the problem. — Lundin, May 17 '16 at 06:39
Is there any other utility that would help me program the microcontroller? I may as well try that... — RishabhHardas, May 17 '16 at 07:01
Why use a serial port? Use some JTAG adapter, goes much faster and is more reliable. — Lundin, May 17 '16 at 07:04
During the prototyping I did it via ST-Link. But now the boards do not have a functionality for ST-Link. Hence Serial Programming. — RishabhHardas, May 17 '16 at 07:20
Can you program it on Windows? Can you program the prototyping board trough the serial port? — followed Monica to Codidact, May 17 '16 at 08:53

score 14 · Accepted Answer · answered Jun 29 '16 at 20:36

Here are a few tips:

Connect serial cable before resetting / powering up the board. Otherwise some transients can mess the serial bootloader up.
Make sure you are using a TTL level USB-to-serial converter instead of a RS-232 cable. RS-232 has inverted level, and worse still, its -15V to 15V voltage range can burn your STM32.
Make sure RX and TX are connected correctly.
Try using stm32flash instead.
Most STM32's serial bootloader does not support baud rate higher than 115200 as I remember. The bootloader can detect baud rate automatically, the one I usually use is 57600.

score 0 · Answer 2 · answered Jul 22 '17 at 17:34

0

Some of these chips are being shipped with locked bootloaders. You will need to use STM32 Flash loader demonstrator to remove the protection. Windows only unfortunately but once it is unlocked you can use any machine.

answered Jul 22 '17 at 17:34

charsi

2,917
22
40

How to flash STM32 via Serial Port

2 Answers2