culebra GUI not scaling at all

Question

i am new to culebra.

I have tried to follow the steps on the wiki page by running.

culebra -G

However, it gives me an oversized image but the command line does not allow me to enter new commands

My image is something like this.

And my command line is something like this.

Is there any step by step tutorials i can follow as i cannot seem to follow the wiki. I am running on windows 7.

score 1 · Accepted Answer · edited Jun 20 '20 at 09:12

1

To scale the window use

python culebra -G --scale=0.5

or whatever value suits your needs.

For some reason it's telling you there are no touchable or clickable views, this may indicate that the dump couldn't be obtained. Try

python dump -a

to check if this is the case.

Edit

I've seen views dumped in your autogenerated culebra script (e.g. no_id1, no_id2, ...) so the case may be you are clicking outside these views.

When you press Ctrl+Z all the clickable and touchable zones are highlighted

edited Jun 20 '20 at 09:12

Community

answered Aug 18 '15 at 14:50

Which view should I be clicking on? The emulator itself or the screen capture? – aceminer Aug 18 '15 at 15:34
You can click on both, depending on the case. If you change the emulator (by interacting with it) then you have to refresh culebra (pressing F5) to reconcile. – Diego Torres Milano Aug 18 '15 at 15:50
Normally, you interact only with the `culebra` window, – Diego Torres Milano Aug 18 '15 at 15:50
I have tried clicking inside the screen capture but it shows the nothing is clickable. If I were to click the emulator and press refresh for the screen capture it will take very long to load before saying not responding – aceminer Aug 18 '15 at 15:51
Yet another trick, if you press Ctrl-Z you'll see the clickable zones. – Diego Torres Milano Aug 18 '15 at 15:51