0

I cannot run state flow diagram from Matlab. I am using Matlab 2013b. Whenever I try to run it it gives a warning:

Warning: The model 'xyz' does not have continuous states, hence Simulink is using the solver'FixedStepDiscrete' instead of solver 'ode4'. You can disable this diagnostic by explicitly specifying a discrete solver in the solver tab of the Configuration Parameters dialog, or by setting the 'Automatic solver parameter selection' diagnostic to 'none' in the Diagnostics tab of the Configuration Parameters dialog

However I have modified the above mentioned two requirement from configuration setup. But it is still showing problem. Do I need to set up some additional software to fix this problem?

joe_young
  • 4,107
  • 2
  • 27
  • 38
user3193794
  • 105
  • 2
  • 12
  • Could you post the diagram or give us a glimpse of how it is, and what do you expect it to do?? – Manex Nov 04 '14 at 11:50

1 Answers1

0

This is just a warning, not an error message, your model will run just fine as is. If you want to get rid of the message, change the solver in the model to FixedStepDiscrete instead of ode4 and it will go away, but it won't change anything in the actual running of the model.

am304
  • 13,758
  • 2
  • 22
  • 40