Connecting QTableView selectionChanged signal produces segfault with PyQt

Question

I have a QTableView in a PyQt application, and I want to keep track of when the selection changes. I've tried connecting the signal to a slot as follows (using the advice on this page:

self.view.selectionModel().selectionChanged.connect(self.selChanged)

where the slot it is connected to is defined as:

def selChanged(self, selected, deselected):
        print "Sel changed"

However, whenever I load the QMainWindow on which the QTableView resides, I get an immediate segmentation fault.

Am I doing something silly here?

There isn't anything obviously wrong in the code you show. Perhaps the issue is somewhere else? Can you post a full example with the issue? — Avaris, Feb 10 '13 at 23:36

score 9 · Answer 1 · edited May 23 '17 at 11:54

9

I was having a similar problem and the fix was here: PySide: Segfault(?) when using QItemSelectionModel with QListView

Namely, replace:

self.view.selectionModel().selectionChanged.connect(self.selChanged)

with two commands:

selectionModel = self.view.selectionModel()
selectionModel.selectionChanged.connect(self.selChanged)

Not sure why this works, frankly.

edited May 23 '17 at 11:54

Community

1
1

answered Nov 01 '14 at 12:42

eric

7,142
12
72
138

score 2 · Accepted Answer · answered Feb 11 '13 at 21:03

This has been fixed now, it turned out that I was using an old version of Qt on that machine - which seemed to cause the crash.

The moral of the story is: if your code is crashing for no sensible reason, check all of your dependencies (in this case Qt and PyQt) are up-to-date.

Connecting QTableView selectionChanged signal produces segfault with PyQt

2 Answers2

Linked

Related