Server Fault Stack Exchange
Server Fault Stack Exchange

Questions tagged [lsi]

LSI is a manufacturer of enterprise storage and networking components.

LSI is a manufacturer of enterprise storage and networking components.

250 questions
1
vote
1 answer

How to map a virtual drive (RAID 0, PERC) to Linux

I have two different RAID arrays on a server. The first virtual drive is a RAID 10 with 4 disks and is already mapped to the OS. Now I have created another array with RAID 0 and one disk. Because the first virtual drive was created and mapped…
seobility
  • 45
  • 1
  • 5
1
vote
1 answer

LSI Megaraid add a disk in RAID 0 besides a configured RAID 10 array

We have an active RAID 10 with four disks. Now we want to add one disk in RAID 0 to the adapter. This is the current configuration: # megacli -LDInfo -Lall -Aall Adapter 0 -- Virtual Drive Information: Virtual Drive: 0 (Target Id: 0) Name …
seobility
  • 45
  • 1
  • 5
1
vote
0 answers

ZFS on Linux Server occasionally stalls and then resumes

Im having an issue which I have a really hard time debugging. Running ZFS, by system "hiccuped", dumped some information into DMESG, and continued working. My ZFS is hosting VMs on ESXi. When this issue occurs, many of the VMs experience block IO…
user1955162
  • 296
  • 3
  • 16
1
vote
2 answers

lsi megaraid 9260 single raid0 disk went unconfigured bad, please help recover data

I had some problem with my server with lsi megaraid 9260 chip(no JBOD support). I cannot recall exactly but I think I had a single drive as r0, and it failed. I need to recover data from it, if possible. I'll describe what happened: One day when I…
platimnekriptu
  • 13
  • 1
  • 4
1
vote
0 answers

0xD1 on megasas2.sys with LSI-9240-8i during data transfer

I have an older Intel S3210SHLX motherboard with a HighPoint 2310 RAID card, running four 500GB drives in a RAID5 array. The OS is WHS2011, and everything is fine, except that I'm running out of room. My solution is four 4TB drives run through an…
Woodrow
  • 11
  • 2
1
vote
1 answer

HP SAS Expander 12Gb max storage limitations

Is the max storage limitation stated in HP's documentation a real limitation or not? I currently have 48TB (8x 6TB in a raid 6) and I just purchased a Norco RPC-4224 and 8 additional drives to double my capacity to 96TB I was planning on using a HP…
chansearrington
  • 13
  • 3
1
vote
0 answers

MegaRAID Rebuild required after PdOffline + PdOnline?

In a RAID6 array with 12 disks I have taken a disk offline to flash new firmware, then brought it online again: MegaCli64 -PdOffline -PhysDrv[8:0] -a0 MegaCli64 -PdFwDownload -PhysDrv[8:0] -f firmware/ConstellationES3-Megalodon-SATA-StdOEM-SN06.lod…
nn4l
  • 1,336
  • 5
  • 23
  • 40
1
vote
2 answers

System fails to boot after successful LSI 9211-8i firmware update

So, here we go. I purchased a used LSI 9211-8i to use in my NAS. I installed the card, attached a few drives, booted the system, and everything looked OK. I'm using FreeNAS and there was a warning saying that my card's firmware and BIOS didn't…
Craig
  • 333
  • 3
  • 9
1
vote
1 answer

How add drive to array using LSI Megaraid Storage Manager

I have an LSI 1068E raid card, with 4 disks, configured as 2 RAID1 pairs. I'm not sure how, but I've ended up with a pair in a degraded state, and one of the disks from that pair shows as unconfigured (spare). I've been through every option on the…
TSG
  • 1,674
  • 7
  • 32
  • 51
1
vote
1 answer

Cannot mount partitions from LSI Software MegaRAID

I have a ThinkServer RD440 running RHEL 7.2 with a LSI MegaRAID which is configured as a RAID 10 over 4 disks. It is configured on a partition level, not the raw disks. The root partition is not part of the RAID. For various reasons the original…
nkr
  • 111
  • 4
1
vote
1 answer

LSI 2108 RAID 5, one disk dead, one more with bad sectors; how can I recover the data?

I have a server with a RAID LSI Logic / Symbios Logic MegaRAID SAS 2108 [Liberator] and 4 disks of 3TB attached, configured as RAID 5. Unfortunately after 3 years of good services one disk died (the plates are gone) and another one have some bad…
pmichelazzo
  • 11
  • 2
1
vote
2 answers

Flashing firmware to hard disks behind LSI controller

We have an Intel RAID Controller RS25DB080 (LSI SAS2208) with four ST2000NM0033-9ZM175 SN03 SATA disks. A hardware RAID10 volume is built using these disks and an Ubuntu Server OS is installed on it. Recently we've found out there's a firmware…
Jacob Becker
  • 53
  • 1
  • 5
1
vote
1 answer

High CPU system time of unknown nature

Environment: Intel Server Board S2600GZ 2 x Intel Xeon CPU E5-2620 128GB DDR3 RAM Intel RAID Controller RS25DB080 (LSI SAS2208) with four ST2000NM0033-9ZM175 SATA disks Ubuntu 12.04.5 LTS / Linux 3.11.0-26-generic x86_64 We have a 4TB hardware…
Jacob Becker
  • 53
  • 1
  • 5
1
vote
1 answer

S5000PSL PCIe slots dead?

Summary: PCIe HBAs do not function in 2 out of 4 slots on board. Setup detail and previous steps: I have an Intel S5000PSL board currently populated with dual xeon CPUs and 32GB RAM (8x4GB). The RAM is new, as the old RAM was previously failing…
David Bugg
  • 13
  • 3
1
vote
0 answers

LSI SAS1068E (aka LSI SAS 3442E-R) bandwidth

Recently I connected LSI SAS 3442E-R and two HP SAS 600GB 10k HDD. My motherboard is AsRock Z97 Extreme6. Disk are configured as JBOD, no raid. Linux lspci shows: 0b:00.0 SCSI storage controller: LSI Logic / Symbios Logic SAS1068E PCI-Express…
Lukasz
  • 63
  • 1
  • 7
1 2 3
…
16 17