Server Fault Stack Exchange
Server Fault Stack Exchange

Questions tagged [crossover]

9 questions
4
votes
1 answer

Solaris crossover via fiber

I have two Sun servers running Solaris 10. Both have Emulex fiber channel cards. I'd like to connect the two in a "crossover" fashion like you would copper ethernet & IPv4. Point being I have a ZFS array attached to one that I'd like to share to…
churnd
  • 4,077
  • 5
  • 34
  • 42
1
vote
1 answer

Network latency caused by incorrect cable?

Our team recently setup a new network and now we are experiencing network latency issues. the flow of traffic is as such: modem -> router -> packet shaper -> cisco3750 switch from router to packet shaper, I believe we used a cross over cable and…
nGX
  • 344
  • 1
  • 6
  • 19
1
vote
2 answers

ethernet cable is connected but It shows unplugged

I told datacenter too connect two of my servers with a crossover cable to each other. But when I try this command ethtool eth0 Settings for eth0: Supported ports: [ TP ] Supported link modes: 10baseT/Half 10baseT/Full …
Mehdi Azizi
  • 51
  • 1
  • 12
1
vote
1 answer

How to connect computers directly with ethernet?

I try to connect two linux computers via a crossover cable. I need help at troubleshooting. I configured ip-address , and on PC1 ifconfig-command shows enp0s7: flags=4163 mtu 1500 inet 192.168.0.1 netmask…
Karl
  • 11
  • 1
0
votes
1 answer

Ethernet patch or crossover router to router

I we have run Ethernet in the house, through a fast Ethernet switch, through a wall patch, over the river and through the woods as it were. From router A, through switch, through wall patch, then to second router B. I read router to router, switch…
Michael W. Powell
  • 1
0
votes
1 answer

Ping Interconnected PCs End-To-End

I have the following network topology: [PC 1] - - - [PC 2] - - - [PC 3] - - - [PC 4] Each machine is connected via a crossover cable. I can ping from PC 1 to PC 2, but how can I configure things so as to ping from PC 1 all the way to PC 4?
THE DOCTOR
  • 185
  • 4
  • 14
0
votes
2 answers

seprate mysql server and eth0 configuration

I have bought another server for mysql. and now the webserver and the mysql server are connected with a crossover cable. I want to configure ips manually. On webserver eth1 is for internet. eth0 is connected to crossover cable. how should I…
Mehdi Azizi
  • 51
  • 1
  • 12
0
votes
1 answer

Send email between servers using a crossover cable and postfix

I don't know where or what I should be reading about when I want to send email between two different domains as follows and please give an example basic Postfix configuration. All conditions in the list below MUST apply: Each domain is on a…
superlinux
  • 141
  • 5
0
votes
1 answer

Access mysql from another computer connected with crossover cable

I have two computers, and i am trying to access mysql via network on port 3322 (mysql listens on this port) Computer A Server: Windows 10 home Added firewall exception to port 3322 (mysql installed and listens on this port) Static IP address:…
Smith
  • 133
  • 5