0

I have a new Cisco 881w AP and I am trying to get to the AP interface.

When i follow the procedures outlined by Cisco, i get asked for a username and password. I have tried all the suggested passwords and all have failed authentication. I get a lot of messages like:

User Access Verification  Username: Not in Bound state. 
*Dec 19 11:26:46.996: %SM_LICENSE-6-BOOTIMAGE_CHANGE_TO_AUTO: Boot image has been changed to autonomous image Please use router EXEC CLI service-module wlan-ap 0 reload to bootup autonomous image on AP  
*Dec 19 11:26:48.156: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an IP!!
*Dec 19 11:26:48.156: %CAPWAP-3-DHCP_RENEW: Could not discover WLC using DHCP IP. Renewing DHCP IP.

The software and IOS versions are:

flash:c880data-universalk9-mz.124-20.T4.bin
Cisco IOS Software, C880  Version 12.4(20)T4,
HopelessN00b
  • 53,795
  • 33
  • 135
  • 209
Les t
  • 1

2 Answers2

1

Reset it to factory default settings with the reset button on the device (hold it down as the device boots up) to clear out whatever configuration it has on it, and then login with the default username and password (admin for both).

HopelessN00b
  • 53,795
  • 33
  • 135
  • 209
0

Thanks for your response . Ultimately i had to reset the AP to factory defaults as you suggested but using the command "service-module wlan-ap0 reset default-config". What i think happened was the unit was not new as thought .The AP was never reset to factory default and had some previous configuration . I actually should have figured it out sooner and not assume the vendor was being truthful. All is well now. Thanks

Les t
  • 1