0

I'm trying to isolate traffic using a VLAN, one of our Linksys SRW2048's and two connections going back to our network from the switch.

Currently I have 3 Vlans, 1 is the default, 2 is for iSCSI, 3 was for General Data. Everything works fine if I leave it on the default - 1.

If I move a PC and one of the connections back to our network onto 3, that PC can't see anything. 1 continues to talk to the network fine.

Both ports in 3 and I have tried them set as Untagged - Access, Untagged - General, and Tagged - General.

Is there a setting I am missing somewhere else?

PImoose
  • 1
  • 1

1 Answers1

1

You need to have some kind of inter vlan routing set up. Your switch may provide this. If not a dedicated router would.

Tim Brigham
  • 15,545
  • 10
  • 75
  • 115