0

The system was working fine when suddenly the drives were no longer available. Upon further inspection I found that the SAS Fault LED was lit on the RAID card and the megaraid software no longer show when booting up the system. The RAID card in use is AOC-S3108L-H8iR but the user manual is of no real help. The only thing it says is

Red: On | SAS Error(s) detected

I've already tried to move the card to a different PCIe slot and to change the cables but even with nothing connected the led keeps burning and the software stays unavailable.

ColmanJ
  • 103
  • 3

1 Answers1

1

Remove the SAS cable, power down and up again, then try to enter the controller's setup during bootup. If that isn't possible the RAID controller's dead and needs replacement.

Zac67
  • 10,320
  • 2
  • 12
  • 32
  • 1
    This was unfortunately the case. I've ordered a new card and replaced it and now it's working again. – ColmanJ Aug 18 '23 at 07:16