0

I can´t access to Cisco AP by http, I have to configure it. After connect to switch, my router (VyOS) show new IP address IP 192.168.1.61 1c:6a:7a:e2:80:63 2020/04/22 10:14:49 MyDHCPServer AP1c6a.7ae2.8063 I cannt ping 

Reply from 192.168.1.61: bytes=32 time<1ms TTL=255
Reply from 192.168.1.61: bytes=32 time<1ms TTL=255
Reply from 192.168.1.61: bytes=32 time<1ms TTL=255
Reply from 192.168.1.61: bytes=32 time<1ms TTL=255
Reply from 192.168.1.61: bytes=32 time<1ms TTL=255

But I can´t access to Cisco AP by http://192.168.1.61 -> ro response.

Mantykora 7
  • 59
  • 2
  • 13

1 Answers1

1

The CAP in the model number says that it was shipped from Cisco with the controller based software image. So you don't configure via a GUI. You can change the image from the controller to the autonomous image. You would need a CCO account to download the new image though.

From Cisco: https://www.cisco.com/c/en/us/products/collateral/wireless/aironet-2600-series/data_sheet_c78-709514.html AIR-CAP2602I-x-K9: Dual-band controller-based 802.11a/g/n AIR-SAP2602I-x-K9: Dual-band autonomous 802.11a/g/n

lanbrown
  • 11
  • 2