Questions tagged [proxmox]

Proxmox Virtual Environment (PVE for short) is an Open Source Server Virtualization Platform, based on Debian, KVM and (LXC for v4 and above, OpenVZ for versions <4.0)

Proxmox VE is a complete open source virtualization management solution for servers. It is based on KVM virtualization and container-based virtualization and manages virtual machines, storage, virtualized networks, and HA Clustering.

513 questions
0
votes
1 answer

Migrate Proxmox VM with VZDump to a system with just QEmu?

So I have a VZDump of a Proxmox VM image. What I want to do is import this to QEmu. How would I go about doing this? So far the results just show me Proxmox to Proxmox and not Proxmox to QEmu.
Definity
  • 127
  • 6
0
votes
0 answers

Proxmox Networking configuration with multiple VM

I have purchased a dedicated server from Hetzner and it comes with a single IP address. I installed Proxmox and now this IP is used to access the web portal. I got another IP address for a VM on this node. I cannot configure other VMs to access…
0
votes
0 answers

Installing foreman in Proxmox, Forward DNS points to 127.0.1.1 / Reverse DNS failed. Your system does not meet configuration criteria

I'm trying to install Foreman in a debian LXC container in Proxmox VE. When I run foreman-installer, I get the following error. Forward DNS points to 127.0.1.1 which is not configured on this server Your system does not meet configuration…
Shodan
  • 101
0
votes
0 answers

Unable to remove ZFS cache device created on another operating system

I used to run SmartOS (Solaris) on a server, but recently moved to Proxmox (Linux). A non-root zpool that was exported from SmartOS was successfully imported to Proxmox - except for the cache device (which was offline at the time). zpool status…
Gareth
  • 31
  • 2
0
votes
1 answer

How to detect packets on mirrored port using Promiscuous mode on a VM running on Proxmox

I have a Proxmox server with four network ports eno1, eno2, eno3, eno4. The eno4 is used for management console and internet access using vmbr0 linux bridge. I have created a vmbr1 bridge for the port mirrored destination port eno1. But I am not…
0
votes
1 answer

Proxmox/Ubuntu LVM issue - Exec format error

I've ran apt update / upgrade on my proxmox server and now I can't seem to boot it into the new kernel (didn't pay too much attention on the update). Any ideas? I can't seem to figure out what's the issue with the LVM executable. Any help would be…
0
votes
1 answer

How to resize Partitions on Proxmox?

Hey im Hosting Proxmox on a Small Hosting Provider and after i added more Space to my "sda" Proxmox refused to start and i wasnt able to go on the WebInterface. I still was able to go into NoVNC to look at the Screen of the VM And when i wanted to…
0
votes
1 answer

Routed IPv6 on internal bridge with virtualized OPNsense router

I'm struggling with adding IPv6 to the internal bridge of my setup, here is what I have: ┌───────────────────────────────────────────────────────────────────────────────────────────────────────────────┐ │ …
Andreas Piening
  • 173
  • 1
  • 9
0
votes
0 answers

Linux Port Forwarding Issue

i don't see the trees anymore. Any hints are appreciated. I have a root server and installed proxmox, i only have one public ip. Went with a routed setup. Set up some basic stuff like 2FA and TLS Certificated and then went on to get pfsense running…
embedded
  • 466
  • 2
  • 6
  • 19
0
votes
0 answers

Private vlans trunk mode for isolation Proxmox VE VM

I tried to isolate the VM of PROXMOX VM 7.2 using VLANs. Every VM has its own VLAN. But for unite many VLAN to one ip subnet with real ip address I try to use Private VLAN with switch VDX-6720 NOS 4.1.3a. In private-vlan trunk host mode all works…
lexxai
  • 14
  • 3
0
votes
1 answer

Error installing mongodb on debian 11 in proxmox container

I try to install mongodb on Debian 11 in a proxmox VE 7.1 container as described in this tutorial https://www.mongodb.com/docs/manual/tutorial/install-mongodb-on-debian/ But I get the following error: error setting ownership of './usr/bin/bsondump':…
0
votes
2 answers

How to deal with dynamic drive name when device mounting hard drives to LXC on Proxmox?

Question Setup On a Proxmox server I create an LXC container with: pct create 101 local:vztmpl/centos-8-default_20201210_amd64.tar.xz --features mknod=1,nesting=1,fuse=1 --ostype centos --storage=CTVM --description "centos glusterfs" --hostname…
0
votes
1 answer

Proxmox VE - problems in setting private network

I have recently bought a test dedicated server from to test proxmox. The installation went smoothly; however, I get stuck in the network configurations. My Use case- I want to create 8 LXC containers and run our 6 microservices, Nginx and Mysql…
0
votes
1 answer

Why does drop_caches increase "available" memory

I encounter low memory issues on proxmox 7 nodes I'm managing. When reading about similar problems I was directed to linuxatemyram.com, after reading this page I started monitoring "available" memory instead of "used" memory. But the problem…
Teriblus
  • 71
  • 5
0
votes
1 answer

Storage for Millions of audio files with search accessibility (if possible)

I was looking for solution for this problem that I have with storing of 7tb worth of files , all of them are audio files these files are recordings of asterisk based server freepbx. At first what I did was installed proxmox on server with ssd for…