Server Fault Stack Exchange
Server Fault Stack Exchange

Questions tagged [openconnect]

OpenConnect is a client for Cisco's AnyConnect SSL VPN.

OpenConnect is a client for Cisco's AnyConnect SSL VPN, which is supported by the ASA5500 Series, by IOS 12.4(9)T or later on Cisco SR500, 870, 880, 1800, 2800, 3800, 7200 Series and Cisco 7301 Routers, and probably others.

OpenConnect is released under the GNU Lesser Public License, version 2.1.

34 questions
0
votes
1 answer

Use openconnect and satsify annyconnect scans

My organisation provides vpn access using cisco anyconnect. I use a linux system and I can connect to vpn using openconnect. I have to use openconnect because anyconnect on linux is not compatible with the authentication method used by the…
aseq
  • 4,610
  • 1
  • 24
  • 48
0
votes
1 answer

Add to route table destnation using this syntax *.mycompany.net

The reason that I am asking this question is that i a using VPN-slice (VPNC) with openconnect While running this command ip route add *.mycompany.net via 0.0.0.0 dev tun0 Error: any valid prefix is expected rather than "*.mycompany.net". What I…
Serge Zoghbi
  • 1
0
votes
0 answers

Openconnect Systemd Unit Hardening: How to restrict access to devices and users

I am hardening my systemd service file for openconnect(8). In my setup, I am using vpn-slice to setup routes (I pass arguments such that it doesn't write to any files) and use various files to define connection parameters and credentials. My target…
steiny
  • 173
  • 2
  • 8
0
votes
1 answer

IPv6 support makes openconnect server vpn connection too slow

I have set up an OpenConnect server (ocserv) on CentOS 8 that is quite fast. However, when I enable IPv6 on it by uncommenting the following line, it becomes painfully slow and upload becomes almost zero. #ipv6-network = fda9:4efe:7e3b:03ea::/48 I…
Mehdi Haghgoo
  • 91
  • 1
  • 10
1 2
3