Server Fault Stack Exchange
Server Fault Stack Exchange

Questions tagged [freepbx]

FreePBX is a Web-based front-end to the Asterisk telephony platform.

FreePBX is a Web-based front-end to the Asterisk telephony platform.

100 questions
2
votes
1 answer

Using Asterisk and FreePBX how can I map extensions to outbound routes

I have a Trixbox server (Asterisk and FreePBX) that has multiple tenants on it. I need these tenants calls to go out via different outbound routes in order to split the bills at the SIP trunk provider end. Essentially the extensions need to be…
SimonJGreen
  • 3,205
  • 5
  • 33
  • 55
2
votes
0 answers

How to forward a call to SIP server

I have a SIP server(Asterisk) I have configured a DID for outbound and inbound. My asterisk server has freepbx installed to manage it. My requirement here is, when anyone calls to this DID call should be forwarded to other SIP server(Nextone SBC).…
Ramesh Kumar
  • 1,770
  • 5
  • 19
  • 29
2
votes
1 answer

How to setup multiple listening ip addresses on Trixbox

I currently have added another ISP to our Data Center and have decided to setup an additional ethernet alias on our Trixbox for the 2nd ip address of our new provider. From what I have read you can just edit the sip_general_custom.conf file and add…
Digital Sniper
  • 33
  • 1
  • 5
1
vote
1 answer

Issues importing new FreePBX instance to GCP with TranslateFailed messages

I configured a new install of FreePBX in VirtualBox and exported to an OVA file to be imported in GCP. I can upload and kick off the import without issue however it fails each time with the following error: [import-ovf]: 2020-01-14T15:47:09Z Error…
Moonark
  • 11
  • 1
1
vote
1 answer

Connecting an old landline phone to FreePBX/VoIP?

I'm looking to hookup a landline phone with an RJ11 connector to my FreePBX server so I can make and receive calls using that phone. If this is possible, what type of adapter would I need?
Leo Takacs
  • 13
  • 2
1
vote
1 answer

Asterisk / FreePBX: How to differentiate incoming calls?

I have an FreePBX/asterisk server setup with two incoming trunk lines with different DIDs, e.g., 555-1111 and 555-2222. However, the lines represent two different entities operated from the same location, so the staff needs to know which line a call…
tufelkinder
  • 125
  • 7
1
vote
0 answers

FReePBX Asterisk Paging announcement dropped after 29 Seconds

I have set up a FreePBX Asterisk Server and I configured paging announcement to a set of extension. When I dial the paging extension the annuncement is played but it stopped after 29 seconds, although the announcement file is longer than 29…
Tech Dog
  • 11
  • 3
1
vote
0 answers

Trouble moving freepbx and a2billing

I'm having trouble moving from FreePBX 2.9.0.15 and A2Billing 1.7.1 to FreePBX 2.11.0.43 and A2Billing 2.2.0 I've transfer the A2Billing data via the backup and restore feature without any problem. This wasn't the case for FreePBX, so I used the…
nameLess
  • 21
  • 5
1
vote
0 answers

How to configure Hylafax to send faxes to folders?

At my current job, we have an established phone/fax system that uses Elastix on top of FreePBX and Hylafax. The guy who set it up did so by himself (a former employee we still have on contract as needed), and many attempts to request information on…
Chance Carter
  • 11
  • 1
1
vote
0 answers

How to know what number was dialled on incoming call

The scenario In the UK. I have one (BT openreach) phone line coming into a Cisco SPA232D. That phone line is ringable on a number, let's say 01235AAAAAA. I have a virtual number, 01235BBBBBB, which is redirected to that line. When people dial this…
Neil Townsend
  • 171
  • 9
1
vote
4 answers

Asterisk flooded by incoming SIP connection from unknown peer

Hello i just installed an new asterisk configuration with freepbx and signed for a SIP account. I setup the SIP trunk with my provider data, launched the console with the asterisk -vvvr command to debug then i noticed that the logs are flooded by…
DoesNotCompute
  • 99
  • 2
  • 8
1
vote
0 answers

sip register success on one host but fail on another host in same local network

I acquired antisip account and setup asterisk (lets say PBX-A) to register. It worked fine. However, I attempted to do so with another asterisk (PBX-B). No luck this time. PBX-A and PBX-B are on the same local network behind NAT. Here is the result…
plsplsme
  • 111
  • 3
1
vote
0 answers

FreePBX server (cent OS base) locks up with no errors or kernel panics

Bit of a baffling situation I've been dealing with for a few days. I have multiple CentOS headless servers (6.4) with the following stats: Core CentOS - 6.4 (Final) Kernel - 2.6.32-358.14.1.el6.x86_64 FreePBX - 4.211.64-9 MoBo - Asus P8H61 CPU -…
PenguinCoder
  • 529
  • 2
  • 6
  • 17
1
vote
2 answers

elastix cdr stop working

CDR was working before 19 march. Unfortunately i dont remember what kind of changes i made to configuration, but this exactly not changes to CDR config. elastix 2.4.0 asterisk 11.7.0 mysql 5.0.95 elastix*CLI> cdr show status Call Detail Record…
dreddko
  • 9
  • 1
  • 2
1
vote
1 answer

Installing FreePBX or Asiterisk-GUI on working server

We have server with Ububuntu and asterisk 1.8 on it without any web-interfaces. Our managers ask me to make them web-interface for looking over config, users, calls and so on. I've installed asterisk-gui on this server but it didn't catch any…
user188083
  • 11
  • 1
1 2
3
4 5 6 7