Server Fault Stack Exchange
Server Fault Stack Exchange

Questions tagged [d-link]

44 questions
1
vote
1 answer

Netgear XSM7224S / DLink 1210-48 Static Lag (Trunk Failure)!

I need to configure a Netgear Switch(XSM7224S) and DLink Switch (DL1210-48) with two trunk ports. I did the same and created a lag (static) between them, afterwhcih a reboot was performed on both of them. I am unable to reach a device from one end…
centosnewbie
  • 13
  • 3
1
vote
1 answer

des3526, how do I untag vlan ports?

I am trying to configure a D-link DES 3526 switch. When I add a VLAN with some untagged ports (via the web interface), the system says that it cannot add untagged vlan ports. What's wrong?
jao
  • 391
  • 2
  • 12
  • 28
1
vote
2 answers

Strange behavior on D-Link wireless router (connection works, some websites load, some do not)

We have a D-Link DI-624M "Super G With MiMo Wireless Router" being used to provide wireless internet for roaming laptops in the office. The desktops are all using wired connections to a switch and working fine. The wireless connections to the D-Link…
Joe Miller
  • 11
  • 1
  • 2
1
vote
1 answer

DLink DIR-635 Wireless Connection Problem

I cannot connect to my dlink via wireless connection. The problem has started recently. At first, the internet connection was getting slower and slower, and at some point in needed to restart the router. I could reconnect to the router easily, but…
Sorantis
  • 113
  • 5
1
vote
1 answer

AirPort for WiFi, DLINK for hardwired

sorry in advance for such a basic question... I have the following daisychain: Phone Socket <-> DSL modem <-> AirPort Extreme <-> DLINK 4 port hub I followed only the very basic setup instructions for both AirPort and DLINK. AirPort is successfully…
KnomDeGuerre
  • 13
  • 2
0
votes
0 answers

D-Link DGS-1510-20 torrent QoS related configurtion

I have two options here. one, I purchased a broken D-Link switch, and two, there is some sort of QOS or firewall related rules that punish my mac pro from connecting to any other device. I have a D-Link DGS-1510-20 switch with Boot PROM Version…
ufk
  • 333
  • 3
  • 8
  • 31
0
votes
1 answer

Convert a LAN port to WAN port

I have D-Link DIR-600M N-Modem. A day ago the WAN port got damaged due to lightning but the other ports still work. I can connect to the modem but the WAN port does not respond. Is there any way I can configure one of the LAN port out of the 4…
Sourav
  • 171
  • 1
  • 8
0
votes
1 answer

Cannot access D-Link DES 3200-10 after resetting account

I've forgot my password and after googling I've found that in recovery mode I can reset my account. Connected to Switch using console port (VT100+ Keyboard compatible) and pressed Shift+6. I accessed recovery mode successfully. using the below…
Suhrob Samiev
  • 101
  • 4
0
votes
0 answers

How to make D-LINK switch IP permanent

I have procured a new D-Link Switch. I have changed its default ip address from 10.90.90.90 to a new ip address. eg - 192.168.100.101. But I am unable set the ip permanently. Whenever I power off the switch its ip is getting reset to 10.90.90.90.…
Sushovan
  • 111
  • 1
  • 2
0
votes
1 answer

Is it possible to have the D-Link DIR-628 run in wireless bridge mode?

Short of installing 3rd party software, does the D-Link DIR-628 run in bridged wireless? I'm trying to have the dlink hook up to an existing linksys wireless router to add more range/get stronger signal.
Matt R
  • 111
  • 2
  • 5
0
votes
1 answer

Extend subnet with dfl-800

i have 2 locations which are connected with vpn over internet with 2 dfl-800 firewalls. Address config in firewall: Location 1 address 192.168.0.0/24. (no dhcp) Location 2 address 192.168.5.0/24. (dhcp handled on sbs 2008) I want to dissolve…
spoekes
  • 101
  • 4
0
votes
2 answers

Routing DSL modem to web server

I am using "D-LINK DSL-2520U ADSL2+ ETHERNET/USB COMBO ROUTER" broadband modem. I hosted a web site using a web server in my PC (port 80). When I tried to access my external IP from my mobile, it took me to the DSL router admin screen. I tried to…
yottabrain
  • 101
  • 3
0
votes
4 answers

Replacing a Cisco Pix Firewall with a D-LINK DFL-CPG310 Firewall

Does anyone have any experience migrating from a Cisco PIX to a so-called non-enterprise grade firewall/router/vpn? I'm a non-networking professional (developer) that flunked the CCNA (only got a 730) and find myself missing the ease of…
Shea
  • 103
  • 4
0
votes
1 answer

Forwarding ports for RDP with SBS 2012

I am having issues forwarding ports on a D-Link DIR-615 router. I have a Windows Server 2012 Essentials set up, including the Remote Web Access (which works properly!). The problem originally is that my client wants to be able to access their PC…
Canadian Luke
  • 885
  • 15
  • 44
0
votes
1 answer

d-link print servers and logging

I have a d-link print server in my network. (dpr-2000) It has a print log which displays which computers in the network have sent print jobs. But it only saves the last 20 history. Is there any way so that i can grab this info from the print server…
rahim asgari
  • 123
  • 3
1
2
3